ASTM C496/C496M-2017 圆柱形混凝土试样劈裂抗拉强度试验方法 Standard Test Method for Splitting Tensile Strength of Cylindrical Concrete Specimens ASTM C496/C496M-2017 圆柱形混凝土试样劈裂抗拉强度试验方法 Standard Test Method for Splitting Tensile Strength of Cylindrical Concrete Specimens

ASTM C496/C496M-2017 圆柱形混凝土试样劈裂抗拉强度试验方法 Standard Test Method for Splitting Tensile Strength of Cylindrical Concrete Specimens

  • 标准类别:
  • 标准大小:
  • 标准编号:ASTM C496/C496M-2017
  • 标准状态:现行
  • 更新时间:2023-05-07
  • 下载次数:
标准简介

1.1 This test method covers the determination of the splitting tensile strength of cylindrical concrete specimens, such as molded cylinders and drilled cores. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 The text of this standard references notes that provide explanatory material. These notes shall not be considered as requirements of the standard. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

标准截图
版权:如无特殊注明,文章转载自网络,侵权请联系cnmhg168#163.com删除!文件均为网友上传,仅供研究和学习使用,务必24小时内删除。