IEC 60384-17-2019 电子设备用固定电容器--第17部分:分规范--固定金属化聚丙烯薄膜介质交流和脉冲电容器 Fixed capacitors for use in electronic equipment – Part 17: Sectional specification – Fixed metallized polypropylene film dielectric AC and pulse capacitors
- 标准类别:
- 标准大小:
- 标准编号:IEC 60384-17-2019
- 标准状态:现行
- 更新时间:2023-05-17
- 下载次数:次
This part of IEC 60384 applies to fixed capacitors with metallized electrodes and polypropylene dielectric for use in electronic equipment.
NOTE Capacitors that have mixed film and metallized electrodes are also within the scope of this standard.
These capacitors may have "self-healing" properties depending on conditions of use.
Capacitors covered by this specification are mainly intended for use with alternating voltage and/or for pulse applications. The maximum reactive power applicable is 10 000 var and the maximum peak voltage is 3 000 V.
Capacitors for reactive power exceeding 500 var, and to which a maximum peak voltage of 2 500 V at 50 Hz can be applied, are not covered by this document, except when they are the highest part of a range of reactive power mainly situated below 500 var at 50 Hz.
This document is not intended to cover capacitance values higher than 20 µF.
Two performance grades of capacitors are covered, Grade 1 for long-life application and Grade 2 for general application.
Capacitors for electromagnetic interference suppression are not included, but are covered by IEC 60384-14.
Capacitors for electrical shock hazard protection (covered by IEC 60065 of IEC technical committee 61) and fluorescent lamp and motor capacitors (covered by IEC 60252-1 and IEC 60252-2 of IEC technical committee 33), and capacitors for use in tubular fluorescent and other discharge lamp circuits (covered by IEC 61048 and IEC 61049 of IEC technical committee 34) are also excluded.dition 3.0 2019-03
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Fixed capacitors for use in electronic equipment –
Part 17: Sectional specification – Fixed metallized polypropylene film dielectric
AC and pulse capacitors
Condensateurs fixes utilisés dans les équipements électroniques –
Partie 17: Spécification intermédiaire – Condensateurs fixes pour tension
alternative et pour impulsions à diélectrique en film de polypropylène métallisé
IEC 60384-17:
标准截图
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-05-17
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-05-17
-
GB/T 706-2016热轧型钢 2023-05-17
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-05-17
-
JB/T 10216-2013电控配电用电缆桥架 2023-05-17
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-05-17
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-05-17
-
JTG D20-2017公路路线设计规范 2023-05-17